Post by Kirkwoodref on Oct 2, 2017 10:18:07 GMT -6
Got a kegerator as a wedding gift and set it up this weekend. I think it’s just a simple standard kegerator for a beginner (the kegerator). Nothing fancy. Purchased a sixtel of Deschutes Fresh Squeezed (cold) and hooked it up on Saturday. We're having a problem with pours being waaaay too foamy. The pours were still too foamy on Sunday after the keg was able to sit overnight with fridge temp set at max (Ordered a digital thermometer so I can tell what temp that will be).
I think it’s a Co2 issue? Our regulator that came with the unit I think is shit/leaky. We have tried to keep keep psi at 10. But then a few hours later it dips to 5/6. When I close all the valves the tank gauge doesn't zero
out when I pull the release valve, either.
Would a new regulator solve my foamy pour problem?
1. Do you have any recommendations on a good regulator that isn’t a leaky piece of shit?
2. What psi would you recommend we have the kegerator set at?
(depends on the beer and temp, right? do you have a rule of thumb?)
3. What other things am I unaware that I should be doing but don’t because I have no fucking clue what I’m doing?
I think it’s a Co2 issue? Our regulator that came with the unit I think is shit/leaky. We have tried to keep keep psi at 10. But then a few hours later it dips to 5/6. When I close all the valves the tank gauge doesn't zero
out when I pull the release valve, either.
Would a new regulator solve my foamy pour problem?
1. Do you have any recommendations on a good regulator that isn’t a leaky piece of shit?
2. What psi would you recommend we have the kegerator set at?
(depends on the beer and temp, right? do you have a rule of thumb?)
3. What other things am I unaware that I should be doing but don’t because I have no fucking clue what I’m doing?
I would start by completely turning the pressure screw until it is "off" and then connect it. It should read zero then and you can slow open it back up to get the psi where you want it. A good rule of thumb is 2 psi per ft of tubing. So if your line is 2 feet long then 10 psi is way too much. Just dial it down until it pours slow enough to leave a 3/4 inch head. If you think it is leaky get some soapy water (StarSan works better but if you aren't a homebrewer doubtful you will have this on hand) and put in a spray bottle and spray it on the valves and connectors. If it is actively bubbling then it shows gas is escaping from that spot. However if it is leaky you will quickly notice a 5 lb tank go dry. It doesn't' take long. Make sure washers on connectors are good - a shitty washer will cost you a lot of money. You can also take your tank and regulator to a homebrew store and I am sure they can help you determine if it sucks or not. 